I have a Hikvision DS-3E1106HP-EI POE switch.
The original configuration was that it was connected to DS-KH6320-WTE1 indoor station device via a ~12m long cat6 stp cable - so far it was working fine.
I've installed a new camera - DS-2CD1353G0-I via cables: due to some limited wiring options, a 2m cat5e stp + ~9m cat6 stp with keystones both end + 10m cat5e stp (a cable tester still indicates everything fine)
The first ~8 hours it was working fine but then both of the devices went offline - none of the ports on the switch come up (no leds indicating either connection or power).
If I unplug the new camera, the indoor station is working fine, however once i connect the camera, both devices go offline (only plugging in the camera also not working - no leds flashing on the switch).
Did I do something wrong with the wiring or the camera just died? (bit problematic mounting it down but if no other advice I'll take it down and check it with the short cable only as well....)
The original configuration was that it was connected to DS-KH6320-WTE1 indoor station device via a ~12m long cat6 stp cable - so far it was working fine.
I've installed a new camera - DS-2CD1353G0-I via cables: due to some limited wiring options, a 2m cat5e stp + ~9m cat6 stp with keystones both end + 10m cat5e stp (a cable tester still indicates everything fine)
The first ~8 hours it was working fine but then both of the devices went offline - none of the ports on the switch come up (no leds indicating either connection or power).
If I unplug the new camera, the indoor station is working fine, however once i connect the camera, both devices go offline (only plugging in the camera also not working - no leds flashing on the switch).
Did I do something wrong with the wiring or the camera just died? (bit problematic mounting it down but if no other advice I'll take it down and check it with the short cable only as well....)