Set area reset after rebooting the NVR

[nart.wdl]

I have set Motion Detection in a specific area with VCA mode 'By Camera' but when the NVR reboot the area reset to be full screen again.
Is anyone else facing this?

NVR: DS-7604NXI-K1/4P(D)
Camera: DS-2CD1043G2-LIU

 

[JB1970]

I have set Motion Detection in a specific area with VCA mode 'By Camera' but when the NVR reboot the area reset to be full screen again.
Is anyone else facing this?

NVR: DS-7604NXI-K1/4P(D)
Camera: DS-2CD1043G2-LIU

Sounds like a firmware bug with the camera. If it’s already up to date there’s nothing to be done but wait for new firmware that fixes it. There was a similar issue with DS-2CD2xxxG1 cameras a few years ago.

 

[nart.wdl]

It might be but it's happening for DS-2CD1047G2H-LIU, DS-2CD1043G2-LIU, and DS-2CD1023G2-LIU.

 

[JB1970]

It might be but it's happening for DS-2CD1047G2H-LIU, DS-2CD1043G2-LIU, and DS-2CD1023G2-LIU.

Three different models but they share the same firmware so it would affect all of them.

 

[nart.wdl]

Thank you. I didn't know that different models can use the same firmware.