01304 827609 info@use-ip.co.uk Find us

Uniview NVR

JackHill290394

New Member
Messages
1
Points
1
Hi,

I have a uniview NVR the NVR208-16S and 12 cameras all the IPC3612ER3-PF28
I have noticed a problem with the motion detection, when recording it detects motion and begins to record for approximately several seconds. It then stops recording while motion is still occurring, and only resumes when new motion has been detected.
This has caused the playback to skip periods throughout the day.
I've adjusted the sensitivity, and tested the cameras in other locations however i still have the same fault.
Any ideas?

Thanks :)
 
Sorry, we're not familiar with the Uniview products.
I'd say, check that you have the very latest firmware for your NVR AND cameras, then look for any settings that might determine how long it records when motion is detected.
 
Back
Top