Hi Dan,
Currently using V4.61.025 build 220905
Yes HDD is installed and does record successfully using motion detection.
The issue is just with recording via a alarm trigger.
Hi there,
I have a DS-7732NI-I4 NVR and I'm struggling to get the alarm input to trigger recording on the device.
In 'basic events' 'alarm input' I have the arming schedule set to 24 hours.
For the linkage method I've set SEND EMAIL and selected to desired channels for trigger recording.
In...
Can anybody help with an error that is constantly reoccurring in my event log.
Exception - IP Channel Alarm Arming Failed
This keeps happening on just one channel.
Any thoughts on how I can fix this?
Paul
Cabling was a cinch. I just purchased a drum of armoured CAT5 cable in and dug it about 8 inches down into the flower beds around the side of the fence. I have a switch in the garage and just one CAT5 cable from the garage back to the house connecting everything to the NVR
Turret cameras can be mounted vertically.
As long as cameras are on the same network they will work. Just connect the wireless cameras to a wireless access point which is on the same network.
You need to run a cable to the wireless camera anyway to power it, so it it not better to just use all...
Does anybody have any experience with ZIP products?
I am used to using Hikvision equipment but wondered how the ZIP products compared?
Worth a try or stick with Hikvision?
Paul
There is no option to do continuous recording and alarm recording as you desire.
The nearest option is "Motion | Alarm", which is motion OR alarm. Why don't you set it like this and turn the sensitivity right up on the motion detection, pretty much as good as recording all of the time?
On a...
Hi there,
In the advanced storage schedule of the NVR I have it set to 10 seconds pre record and 10 seconds post record. I have however set each of the GJD's to latch on for 30 seconds once the are triggered. So I get a total record time of 50 seconds but it is a definite trigger so not a waste...
Hi all,
Just to let you know I've figured out a solution to my problem. Managed to get some wireless PIR's that connect back to a controller with a volt free output. Got a little package where up to 3 PIR's can be connected to one controller and you can set the time that the alarm latches up to...
NVR - DS-7732NI-I4/16P/KB
Firmware V4.1.50 build 180227
I have recently set up my NVR with PIR's on an alarm input to provide more reliable recording when somebody is on the driveway. Is it possible to differentiate the record duration of an alarm to that of video motion detection?
I was...